TM 5-5420-202-20-4
SMOKE GENERATOR SOLENOID REPLACEMENT (Sheet 5 of 5)
Position assembled solenoids (B) and
10.
bracket (E) to engine.
Using 3/4 inch socket, install and tighten
11.
two screws (J) to secure bracket (E)
to engine.
Install lockwire (K).
12.
Using 7/8 inch wrench, connect elbow-
13.
to-solenoid hose (L) to 90-degree elbow
(c).
Using 11/16 inch wrench, connect output
14.
fuel hose (M) to 45-degree elbow (D).
Manually connect electrical connectors (N) to solenoids (B).
15.
16.
Using 7/16 inch wrench and 7/16 inch socket, install nut and screw (P) to secure ground
wire (Q) to bracket (E).
Start engine (TM 5-5420-202-10). Run engine until normal operating temperatures are
17.
reached. Run engine at 1600 rpm and activate smoke generator. Observe operation.
Shut down smoke generator. Shut down engine.
Check system for any possible fuel leaks. Correct leaks as necessary.
18.
Install engine shroud (page 9-3 1).
19.
TA248770
End of Task
21-29