TM 5-5420-202-34
ACCELERATOR CONTROL LINKAGE ASSEMBLY REPLACEMENT (Sheet 2 of 6)
REMOVAL:
NOTE
Steps 1 thru 6 are performed inside crew compartment at the rear left
bulkhead near floor of vehicle.
Using pliers, remove cotter pin (A) from straight pin (B). Throw cotter pin away.
1.
2.
Using pliers, remove straight pin (B) from clevis (C).
While holding tube (D) clear of clevis (C), use 7/16 inch wrench to hold rod end (E) and
3.
1/2 inch wrench on jamnut (F) to loosen jamnut and remove rod end (E).
Using 1/2 inch wrench, remove jamnut (F).
4.
5.
Using 9/16 inch socket, remove two nuts (G) and two lockwashers (H) securing flange
(J).
Remove flange (J).
6.
Go on to Sheet 3
4-94
