TM 5-5420-202-34
ACCELERATOR CONTROL LINKAGE ASSEMBLY REPLACEMENT (Sheet 3 of 6)
7.
Using 9/16 inch socket, remove two screws (K), lockwashers (L), and plate (M) from
base of accelerator control linkage assembly (N).
8.
Using 9/16 inch socket, remove two screws (P), lockwashers (Q), and flat washers
(R) from upper end of accelerator control linkage assembly (N).
Using both hands, slide entire accelerator control linkage assembly toward rear of vehicle
9.
until tube assembly is free of bulkhead.
10.
Using both hands, lift and remove accelerator control linkage assembly (N) from engine
compartment.
11.
Using 9/16 inch socket and 9/16 inch wrench, remove two screws (S), four flat washers
(T), two lockwashers (U), and two nuts (V) securing bracket (W) to accelerator
control linkage assembly (N). Remove and retain bracket (W) for installation onto
replacement accelerator control linkage assembly.
CLEANING AND INSPECTION:
Dry cleaning solvent P-D-680 is toxic and flammable.
To prevent
personal injury, wear protective goggles and gloves and use only in a
well-ventilated area. Avoid contact with skin, eyes, and clothes and
don't breathe vapors. Do not use near open flame or excessive heat.
The flash point for Type #1 Dry Cleaning Solvent is 100F (38C) and
for Type #2 is 138F (50C). If you become dizzy while using cleaning
solvent, get fresh air immediately and get medical aid. If contact with
eyes is made, wash your eyes with water and get medical aid
immediately.
1.
Using rags and dry cleaning solvent, clean entire housing assembly.
2.
Inspect for cracks, damage, and wear. Replace if required.
Go on to Sheet 4
4-95
