TM 5-5420-202-34
SHIFTING CONTROL SHIELD SUPPORT REPLACEMENT (Sheet 1 of 2)
TOOLS:
Ratchet with 1/2 in. drive
Torque wrench with 1/2 in. drive
(0-175 lb-ft) (0-237 N . m)
5/8 in. combination box and
and open end wrench (2 required)
1/2 in. socket with 1/2 in. drive
1/2 in. open end wrench
REFERENCE:
TM 5-5420-202-20
SUPPLIES:
Lockwashers (8 required)
PRELIMINARY PROCEDURES:
Remove right fuel tank (page 4-9)
Disconnect control rod at rear link assembly (TM 5-5420-
202-20)
REMOVAL:
Using 1/2 inch socket, remove four bolts (A) and lockwashers (B). Remove straps (C).
1.
Slide rear shield (D) back approximately 2 inches toward rear of vehicle.
2.
Using two 5/8 inch wrenches, disconnect rear control rod (E).
3.
Remove shield (D) and control rod (E).
4.
Remove front shield (F) from vehicle.
5.
6.
Using 1/2 inch wrench to hold screw (G), use 1/2 inch socket to remove four nuts (H),
lockwashers (J), and washers (M) from screws (G).
Remove four screws (G) and two supports (K) from plates (L).
7.
Go on to Sheet 2
