TM 5-5420-202-34
FINAL DRIVE REPAIR (Sheet 18 of 30)
91.
Inspect output shaft bearing (AT)
and drive gear bearing (AS) for
serviceability in accordance with
TM 9-214. Replace bearings as
necessary. If bearing (AS) must be
replaced, refer to steps 73 thru 77
for removal of bearing from drive
gear (U).
ASSEMBLY:
NOTE
When installing preformed packings or o-ring, ensure there
are no burrs, nicks, or sharp edges which could cut or
damage these parts during installation. Use oil (Item 16,
for ease of installation.
1.
Apply adhesive to output shaft (A) in area
indicated and to five output shaft holes, 1/8 inch
below flange surface.
NOTE
Preformed packing (B) is part of late
model spacers (C). If preformed packing
(B) is installed on spacer (C), go to step 3.
2.
Apply oil to preformed packing (B) and install on
spacer (C).
3.
Install spacer (C) on shaft (A), with
wide portion toward shaft flange, and
seat spacer (C) against flange.
Go on to Sheet 19
7-18 Change 2
