TM 5-5420-202-34
FINAL DRIVE REPAIR (Sheet 28 of 30)
74.
Using suitable lifting device, position
assembled carrier (N) on its side and sup-
port with wood blocks.
75.
Install remaining 17 bolts (AM) to secure
case (U) to carrier(N). Use 7/8 or 1 inch
socket as required to tighten bolts.
76.
Using torque wrench, tighten 20 bolts
(AM) to 110-130 lb-ft (149-176 Nm) in
sequence indicated.
Using torque wrench, retighten 20 bolts
77.
(AM) to 190-230 lb-ft (257-312 Nm) in
same sequence.
Apply sealing compound (Item 9,
78.
and, using 5/16 inch allen wrench, install
and tighten four setscrews (AN) into
case (U).
If studs (AP or AQ) were removed from
79.
case (U) during disassembly or repair,
apply sealing compound (Item 9,
compound (Item 8, Appendix B) to
threads in case (U). Install studs into
case (U) so that remaining length above
case surface is as listed below:
Studs AP - 2.25 0.06 in.
Studs AQ - 2.88 + 0.06 in.
- 0.00 in.
Go on to Sheet 29
7-28 Change 2
