TM 5-5420-202-34
FINAL DRIVE REPAIR (Sheet 27 of 30)
66.
Using torque wrench, tighten eight
screws (AJ) to 50-60 lb-ft (68-81 Nm) in
sequence shown.
67.
Using torque wrench, retighten screws
(AJ) to 95-115 lb-ft (129-156 Nm).
Install lockwire on pairs of screws (AJ).
68.
69.
Position carrier (N) on wood blocks.
70.
Place new gasket (AK) on carrier (N).
71.
Using suitable lifting device, position
case (U) over carrier (N).
72.
Carefully guide pinion gear (AB) thru
bearing and seal in case (U) and aline
case with dowel pins (AL) in carrier (N).
Apply pressure evenly to mate case (U)
with carrier (N).
73.
Install three bolts (AM) through carrier
(N) into case (U) to keep units together.
Go on to Sheet 28
Change 2
7-27