TM 5-5420-202-34
FINAL DRIVE REPAIR (Sheet 24 of 30)
44.
Install inner race (AA) on pinion gear
(AB) with flange toward gear segments.
45.
Place race (AA) and pinion gear (AB) in
press with splined end up.
46.
Apply pressure to splined end of pinion gear
(AB) until race (AA) is seated on pinion
gear. Release arbor press pressure.
47.
Install second race (AC) on pinion gear
(AB). Place 10 inch section of 3-1/8 inch
I.D. pipe over splined end of pinion gear
(AB) so pipe engages race (AC).
48.
Using arbor press, apply pressure to pipe
until race (AC) is fully seated on pinion
bearing shoulder.
NOTE
If output bearing or gear set was
replaced, go to step 49. If bearing or
gear set was not replaced, the bearing
is still on the drive gear; go to step 54.
Lightly grease drive gear (AD) mating
49.
surface.
Position drive gear (AD) in arbor press on
50.
supporting material.
Position bearing (AE) on drive gear (AD).
51.
Position bearing installer over drive gear
52.
(AD) shaft on bearing (AE) inner race.
Go on to Sheet 25
Change 2
7-24
