TM 5-5420-202-34
FINAL DRIVE REPAIR (Sheet 25 of 30
CAUTION
Place supports under center of
drive gear (AD) to prevent damage
during pressing operation.
Position metal block on bearing installer.
53.
Using arbor press, apply pressure to
plate until bearing (AE) is fully seated
on drive gear (AD).
54.
Position drive gear (AD) in carrier (N).
55.
Using two pry bars positioned directly
across from each other, carefully pry
drive gear (AD) up and mesh drive gear
(AD) with pinion gear (AB).
56.
Carefully lower drive gear (AD) and
pinion gear (AB) into carrier (N) until
seated.
57.
Apply oil to threads of output shaft (A)
and nut (AF).
58.
Install self-locking nut (AF) onto output
shaft (A). Using special box wrench,
tighten nut (AF).
Go on to Sheet 26
7-25
Change 2