TM 5-5420-202-34
TRACK ADJUSTING LINK REPAIR (Sheet 3 of 13)
Using 7/16 inch socket, remove grease
8.
fitting (C) from cylinder (F).
Using 3/8 inch wrench, remove pipe plug
9.
(N) from cylinder (F).
Put shaft assembly (E) in vise.
10.
11.
Using 15/16 inch socket, remove screw
(P) from shaft (E).
12.
Remove follower (Q), cup (R), and piston
assembly (S) from shaft (E). Throw cup
(R) away.
Remove packing (T) from inside edge of
13.
piston (S) with knife. Throw packing (T)
away.
14.
Remove packing (U) and packing retainer
(V) from groove in piston assembly (S)
with knife. Throw packing (U) and retainer
(V) away.
15.
Remove support (W) and nut (X) from
shaft (E). Take shaft (E) out of vise.
Go to Sheet 4
9-31
