TM 5-5420-202-34
TRACK ADJUSTING LINK REPAIR (Sheet 1 of 13)
PROCEDURE INDEX
PROCEDURE
PAGE
Disassembly
9-29
Inspection
9-32
Assembly
9-33
Testing
9-35
TOOLS:
7/16 in. socket with 1/2 in. drive
Grease gun
3/4 in. socket with 1/2 in. drive
Hammer, dead blow
15/16 in. socket with 1/2 in. drive
Knife, pocket
3/8 in. combination box and open end
Pliers, slip joint
wrench
Ratchet with 1/2 in. sq. drive
1/2 in. combination box and open end
Tape, measuring
wrench
Torque wrench with 1/2 in. drive
5/8 in. combination box and open end
(0-175 lb-ft) (0-237 Nm)
wrench
Vise
7/8 in. combination box and open end
wrench
SPECIAL TOOLS: Spanner wrench (Item 12, Chapter 2, Section I)
Test fixture (Item 13, Chapter 2, Section I)
Packing (as required)
SUPPLIES:
Bearing
Rags (Item 28, Appendix B)
Brush (Item 2, Appendix B)
Retainer, packing
Cup
Gloves (Item 31, Appendix B)
Fitting, grease
Sealing compound (Item 34, Appendix B)
(2 required)
Dry cleaning solvent (Item 12, Appendix B)
Goggles (Item 32, Appendix B)
Wood block, 8 in. x 8 in. x 18 in.
Grease (Item 14, Appendix B)
Lockwasher (2 required)
Go on to Sheet 2
9-29
