TM 5-5420-202-34
TRACK ADJUSTING LINK REPAIR (Sheet 6 of 13)
11.
Using 7/16 inch socket, install safety relief
valve (L) in cylinder (M).
12.
Using 7/16 inch socket, install grease
fitting (N) in yoke (P) of shaft assembly
(Q).
13.
Using 7/16 inch socket, install support
(R) on yoke (P) with two screws (S) and
new lockwashers (T)
Apply a heavy coat of grease to inside
14.
of cylinder (M) and to shaft assembly
(Q).
15.
Insert shaft assembly (Q) into cylinder
(M) until shaft assembly (Q) is fully seated
in cylinder (M).
Using spanner wrench, tighten nut (B)
16.
on shaft assembly (Q) until nut (B)
is seated against cylinder (M).
17.
Using 3/4 inch socket, install locking screw
(U) in cylinder (M) to hold nut (B), but
do not tighten screw (U) fully.
Go on to Sheet 7
9-34
