TM 5-5420-202-34
TRACK ADJUSTING LINK REPAIR (Sheet 7 of 13)
TESTING:
1.
Put track adjusting link (A) in test fixture
(B) with yoke (C) of link shaft (D) against
test fixture stop block (E).
2.
Put test fixture pin (F) in bearing (G) of
track adjusting link (A).
3.
If testing a right side track adjusting link,
aline hole A of test fixture slide (H) with
hole 2 in test fixture frame (J) as shown.
If testing a left side track adjusting link,
aline hole B of slide (H) with hole 2 in
test fixture frame (J). Make sure shoulder
of pin (F) is completely inside bearing
(G) on both sides and that flat side of
pin (F) is firmly seated against slide (H).
4.
Lock slide (H) in position with locking pin (K) through hole 2 of test fixture frame (J).
Secure pin (K) with clip (L).
5.
Turn needle valve handle (M) fully clockwise to close.
Go on to Sheet 8
9-35
