ARMY TM 5-5420-212-10-1
MARINE CORPS TM 08676A-10/1-1
The bridge will be supported on the rollerbeam and building pedestals, and it is necessary to level and square the
girders so that the bankseat beam will connect to the top panels. This is achieved by:
(1)
Remove building pedestal from under higher girder (B) so its end can be lowered as well as raised.
(2)
Two personnel steady the rear most panel on girder (B).
(3)
Unlock the roller beam roller under girder (B) so that it can move over the roller.
(4)
Engage the dowels and sockets of bankseat beam and top panel of girder (A). DO NOT close shoot-bolts.
(5)
Move free girder (B) sideways, if necessary, to engage dowels and sockets of bankseat beam and top panel
of girder (B).
(6)
Move bankseat beam sideways in the appropriate direction to make the gaps between the compression faces
parallel.
(7)
Raise/lower bankseat beam at the end of girder (B) until all shootbolts can be closed.
(8)
Insert panel pins into bankseat beam and top panels as three personnel on inside of bankseat beam lift, and
three personnel on outside bankseat beam push down, to compress the resilient mounts.
(9)
Put retainer clip through end of panel pins.
4-26
