ARMY TM 5-5420-212-10-1
MARINE CORPS TM 08676A-10/1-1
b.
Double Story
(1)
Carry junction panel towards last bay of bridge.
(2)
Engage dowels and sockets of junction panel to top panel.
(3)
When compression faces contact, lift the shootbolt and turn handle to the left to lock shootbolt.
(4)
Lift and push forward to compress resilient mounts and enable pin person to insert bottom panel pin until
shoulder touches jaw. Additional person to push down on bottom jaw to assist.
(5)
Push forward with additional person pushing on top jaw to compress resilient mounts and enable pin person
to insert panel pin in upper jaw until shoulder touches jaw.
(6)
Put retainer clips on both pins.
(7)
Connect top panel (E) to junction panel (para. 4-6a.).
(8)
Carry end taper panel towards junction panel and engage resilient mounts in guide slots to line up pin hole in
jaws.
(9)
Slide in panel pin until shoulder butts against jaws.
(10) Lower other end of end taper panel to the ground.
(11) Put retainer clip through end of pin.
4-27
