ARMY TM 5-5420-212-10-1
MARINE CORPS TM 08676A-10/1-1
4-10.
CONNECTING LAUNCHING NOSE ROLLER
The launching nose roller and launching nose cross girder supports the launching nose on single story bridges
over 8 bays, and all double story bridges. To connect the launching nose roller to the bankseat beam proceed as follows:
a.
Hook the nose roller on bankseat beam rail.
b.
Push launching nose pin through bankseat beam center bracket and bottom of nose roller.
c.
Put retainer clip through nose pin.
4-11.
CONNECTING/DISCONNECTING LAUNCHING NOSE CROSS GIRDER & POSTS
The launching nose cross girder holds the near bank end of launching nose in position set for construction and
launch. The drills for connecting are slightly different for SS and DS, but the drill for setting position is the same.
a.
Single Story
4-33
