ARMY TM 5-5420-212-10-1MARINE CORPS TM 08676A-10/1-16-17.PICKET TYPE INSTALLATIONUse hammer to drive pickets into bank at 1 ft (0.3m) intervals along the outside edge of near bankseat bream.Repeat this procedure for far bank bankseat beam.6-18.APPROACH GUY INSTALLATIONa.GeneralDuring installation, anchorage pins will be used in end taper panels for connection of approach guy cables. Thistype of anchorage is installed during construction, but can, if required, be installed once bridge is put on ground,b.Installation(1)Insert anchorage pins in anchorage pin holes in end taper panels of far bank end of bridge.6-73
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
