ARMY TM 5-5420-212-10-1
MARINE CORPS TM 08676A-10/1-1
(4)
Coil cable on top of panel and secure to carrying bar bracket with light rope.
(5)
Insert near bank anchorage pins in anchorage pin holes in end taper panels of near bank end of bridge
[as in step (1)].
(6)
Attach anchorage lug to end of each pin and secure with retaining pin and retainer clip.
NOTE
Bridge must be boomed until anchorage pin is in front of roller beam nearest edge of gap, before
lug can be attached [as In step (2)].
(7)
Attach loop of approach guy cable to lug with bracing pin and secure with retainer clip [as in step (3)].
(8)
Coil cable on top of panel and secure to carrying bar bracket with light rope [as in step (4)].
NOTE
The following step can be performed immediately after arrival on site, depending on the
availability of personnel.
6-75