TM 5-5420-226-20-2
ENGINE OIL FILLER CAP REPLACEMENT (Sheet 3 of 3)
INSTALLATION:
Place new gasket (A) on cap assembly
1.
(B).
Place two preformed packings (C) on
2.
cap assembly (B).
Place cap assembly (B) in position on
3.
engine access plate (D).
Using socket, install two screws (E)
4.
and washers (F).
5.
Place engine access plate (D) in position
on powerplant and push down until seated
6.
Using socket, install eight screws and
washers (G).
Place plate with electrical connectors
7.
(H) in position.
8.
Using socket, install four screws and
washers (J).
Open filler cap (B), insert gage (K)
9.
and close filler cap (B).
Install engine shroud (page 9-31).
10.
11.
Install powerplant (page 5-14).
TA107552
End of Task
6-83