TM 5-5420-226-20-2
FUEL-WATER SEPARATOR CONTROL ASSEMBLY REPLACEMENT (Sheet 3 of 5)
12. Using screwdriver, remove two screws
and two cushioned clamps (J) and mount-
ing plate (K) at right side and above
fuel-water separator control assembly (L).
NOTE
It may be necessary to use
pliers to start removal of con-
nectors in steps 13 and 14.
Manually disconnect engine electrical
130
harness connector (M) from fuel-water
separator control assembly (L).
14. Manuallv disconnect solenoid valve
electrical lead (N) from fuel-water
separator control assembly (L).
15.
Using 5/16 inch wrench, remove screw
and cushioned clamp (P) holding
solenoid valve electrical lead (N)
to fuel-water separator control
assembly (L).
Using 5/16 inch wrench, remove three
16.
remaining screws and washers (Q)
holding fuel-water separator control
assembly (L) to" mounting plate.
Remove control assembly.
Go on to Sheet 4
TA107825
7-218