TM 5-5420-226-20-2
ACCELERATOR LINKAGE ENGINE CONTROL REPLACEMENT (Sheet 2 of 3)
3.
Using 7/16 inch wrench, remove screw (D).
4.
Using two 7/16 inch wrenches, remove screw
(E) and nut (F).
5. Using 1/2 inch wrench and 7/16 inch wrench,
loosen nuts (G) from stud (H).
6. Unscrew rod ends (J) and nuts (G) from stud (H).
NOTE
Count and write down number of turns needed to
unscrew rod ends (J).
CLEANING AND INSPECTION:
Clean all parts using dry cleaning solvent and clean rags.
1.
Inspect all parts for bends, cracks, stripped threads, wear, or other defects. Replace
2.
defective parts.
INSTALLATION:
Install nuts (A) onto stud (B).
1.
Screw rod ends (C) to same number of
2.
turns recorded for removal on stud (B).
Using 1/2 inch wrench and 7/16 inch
3.
wrench, tighten nuts (A).
Position rod assembly in place.
4.
Using two 7/16 inch wrenches, install
5*
screw (D) and nut (E).
Using 7/16 inch wrench, install screw (F).
6.
TA108067
Go on to Sheet 3
7-361