TM 5-5420-226-20-3
SHIFTING CONTROL REAR ROD AND LEVERS REPLACEMENT (Sheet 1 of 4)
PROCEDURE
INDEX
PAGE
PROCEDURE
Removal
Installation
TOOLS:
Slip joint pliers
7/16 in.open end wrench
9/16 in.open end wrench (2 required)
Flat-tip screwdriver
Spring pin MS3906-161
SUPPLIES:
Block tracks to prevent vehicle movement
PRELIMINARY PROCEDURES:
Place shift lever in reverse (TM 5-5420-226-10)
Remove top deck (page 16-21)
Remove transmission shroud (page 9-2)
REMOVAL:
Using pliers, remove cotter pin (A) from
1.
transmission shaft stud (B).
2.
Using 9/16 inch wrench, remove nut
and washer (C) from transmission shaft
stud (B) .
Go on to Sheet 2
