TM 5-5420-226-20-3
SHIFTING CONTROL REAR ROD AND LEVERS REPLACEMENT (Sheet 3 of 4)
INSTALLATION
1.
Using 9/16 inch wrench, install jamnut
(A) onto rod (B).
2.
Using 9/16 inch wrench, install rod end
(C) onto rod(B) past witness holes.
Position rod end (C) into clevis of lever
3.
(D).
NOTE
4.
Using 9/16 inch wrench, install bolt
(E) through clevis of lever(D) and rod
Make sure that clevis
end (C).
opening on lever (F) is
alined with spline on trans-
mission stud (G) before in-
stalling lever (F).
5.
Install lever (F) onto transmission shaft
stud (G). Using hand, install screw (H)
through lever (F).
6.
Using 7/16 inch wrench, install screw
(J) and jamnut (K) into lever (F).
7.
Install washer (L) and nut (M) onto screw
(H). Using two 9/16 inch wrench, tighten
nut (M).
8.
Using 9/16 inch wrench, install washer
and nut (N) onto transmission shaft
stud (G).
Using pliers, install new cotter pin (P)
9.
through nut (N) and transmission shaft
stud (G) .
TA169038