TM 5-5420-226-20-3
BRAKE LEFT HAND SLAVE CYLINDER AND TUBE ASSEMBLY REPLACEMENT (Sheet 2 of 4)
Position container under slave cylinder
1.
(A) to catch brake fluid.
Using 13/16 inch wrench, remove bolt
2.
(B) and two gaskets (C). Throw away
gaskets.
NOTE
Allow brake fluid to drain, then throw
away fluid. Check bolt (B) to make
sure internal passages are open and
clean.
3.
Using 11/16 inch wrench, disconnect
nut on tube assembly (D) from tee (E)
and install plastic cap on tee.
4.
Install plastic plug in nut of tube assembly
(D) and masking tape over parts in other
end.
5.
Using 9/16 inch socket, disconnect mounting
nut (F) from stud (G).
Move slave cylinder (A) forward and
6.
wiggle it side to side while pulling up
until catch (H) clears housing assembly.
Continue this procedure until it comes
loose from housing assembly (J).
7.
Using putty knife, remove packing (K)
from groove of slave cylinder (A) and
throw away.
Go on to Sheet 3
TA169180
13-55
