TM 5-5420-226-20-3
BRAKE RIGHT HAND SLAVE CYLINDER AND TUBE ASSEMBLY REPLACEMENT (Sheet 3 of 6)
Using 9/16 inch mcket, disconnect mounting
9.
nut from stud.
Move slave cylinder (H) forward and
10.
wiggle it side to side while pulling up
until catch clears housing assembly.
Continue this procedure until it comes
loose from housing assembly.
Remove slave cylinder (H).
11.
Using putty knife, remove packing (M)
12.
from groove of slave cylinder (H) and
throw away packing.
CLEANING AND INSPECTION:
Cleaning agent specified is flammable. Use only in well ventilated areas. Keep away from
flames, sparks, or heat. Do not smoke while using. Prevent contact with eyes, mouth, and/or
skin. Wear rubber gloves when performing cleaning procedures.
Clean all metallic parts in dry cleaning solvent.
1.
Inspect all parts for damage or wear. Replace all unserviceable parts.
2.
Inspect tube assembly nut for cracks. Replace tube assembly if any cracks are found.
3.
4.
Check bolt (F) for open and clean internal passages.
TA169185
Go on to Sheet 4
