TM 5-5420-226-20-3
BRAKE LEFT HAND SLAVE CYLINDER AND TUBE ASSEMBLY REPLACEMENT (Sheet 3 of 4)
CLEANING AND INSPECTION:
Cleaning agent specified is flammable. Use only in well ventilated areas. Keep away
from flames, sparks, or heat. Do not smoke while using. Prevent contact with eyes,
mouth, and/or skin. Wear rubber gloves when performing cleaning procedures.
1.
Clean all metallic parts in dry cleaning
solvent.
2.
Inspect all parts for damage or wear.
Replace all unserviceable parts.
3.
Inspect tube assembly nut for cracks.
Replace tube assembly if any cracks
are found.
INSTALLATION:
Insert new packing (A) in groove of
1.
slave cylinder (B).
Position and slide slave cylinder (B)
2.
down over housing assembly push rod (C).
Wiggle it back and forth while pushing
down. Push slave cylinder (B) forward
when on housing assembly (D), then
pull back to make sure catch (E) engages
in housing assembly (D).
Tighten mounting nut (F) to stud (G)
3.
finger tight.
4.
Using 9/16 inch socket, tighten mounting
nut (F).
TA169181
Go on to Sheet 4