TM 5-5420-227-24
EJECTION CYLINDER REPLACEMENT (RIGHT) (Sheet 3 of 4)
INSTALLATION :
Position ejection cylinder (A) in tongue (B).
1.
Manually install two screws (C) and new lock-
2.
washers (D) in bottom of tongue to secure
ejection cylinder (A).
Using 1-1/2 inch wrench, tighten two screws
3.
(C) and lockwashers (D).
Manually start plug (E) on threads Of
4.
cylinder rod (F).
Using punch in hole of plug (E),
5.
tighten plug (E) while holding
cylinder rod (F) from turning with
screwdriver.
NOTE
Remove protective coverings and put
pipe tape on all male hydraulic
fittings.
Using 3/4 inch wrench, install nipple
6.
(G) in ejection cylinder (A).
Using 3/4 inch wrench to hold nipple (G),
7.
use adjustable wrench to install tee (H).
Manually place collars "CA" (J) and "CD"
8.
(K) on elbows (L, M) and collar "CB" (N)
on elbow (P).
Manually install elbow (P) on ejection
9.
cylinder (A) and elbows (L, M) on tee (H).
Using adjustable wrench, tighten elbows (L, M
10*
to tee (H) and elbow (P) to ejection cylinder (A).
Manually install hose assemblies "CA" (Q)
11.
to elbow (L), "CD" (R) to elbow (N), and
"CB" (S) to elbow (P).
TA170465
on to Sheet 4
GO
3-243