TM 5-5420-228-24
CLUTCH ASSEMBLY REPLACEMENT AND REPAIR (Sheet 1 of 9)
PROCEDURE INDEX
PAGE
PROCEDURE
Removal
Disassembly
Cleaning and Inspection
Assembly
Installation
Chisel
TOOLS: Flat-tip screwdriver
Ratchet with 1/2 in. drive
7/16 in. open end wrench
3/16 in. drive pin punch
Hammer
Long round nose pliers
9/16 in. socket with 1/2 in. drive
1/4 in. socket head screw key
9/1 6 in. open end wrench (2)
Bearing puller
3/8 in. socket head screw key
Arbor press
Gloves (Item 27, Appendix D)
Dry cleaning solvent (It em 15, Appendix D)
SUPPLIES:
Rags (Item 12, Appendix D)
Goggles (Item 26, Appendix D)
Shield (Item 33, Appendix D)
Compressed air source
1/16 in. locating pin
Paper (Item 23, Appendix D)
Grease (Item 9, Appendix D)
Drive screws (4 required)
Cotter pins (3 required)
Drive screws (4 required)
Remove pump-clutch drive (page 4-23)
PRELIMINARY PROCEDURES:
REMOVAL:
Push down o n hand lever (A) to make sure clutch.
1.
is disengage
TA251684
Go on to Sheet 2
