TM 55-1945-205-24-2
0267 00 2
0267 00
a.
Remove lock nut (2) and washer (3) from throttle lever pin (4).
b.
Remove throttle control cable (1) from throttle lever pin (4).
c.
Remove throttle control cable (1) from cable retainer (5) by removing screw (6).
CAUTION
The shift control cable is secured by the rubber grommet near the throttle control
cable. Care must be given to ensure the shift control cable is not damaged during
grommet removal.
d.
Remove rubber grommet (7) from anchor block pocket (8) on front of lower engine cover (9).
e.
Remove throttle control cable (1) from rubber grommet (7).
f.
Return rubber grommet (7) to anchor block pocket (8).
2.
Remove and discard all in line tiedown straps.
3.
Remove and retain all in line wire bundle clamps.
4.
Remove throttle control cable (1) and discard.
INSTALL RHIB THROTTLE CONTROL CABLE
NOTE
Both the throttle and shift control assembly and the engine gearcase must be in neutral
positions prior to installation of the throttle control cable.
1.
Lay out new throttle control cable (1) between operators console and engine, providing a slack area in front of the
engine to allow for engine movement.
2.
Install RHIB throttle and shift control assembly. (WP 0269 00)
3.
Install throttle control cable (1) on the engine.
7,8 (HIDDEN)
9
5,6
1
2,3,4
