TM 55-1945-205-24-2
0267 00 3/4 blank
0267 00
a.
Verify fast idle lever is down in RUN position.
b.
Move throttle and shift control handle to the REVERSE position to fully extend throttle control cable (1).
WARNING
c.
Apply grease to extended cable portion of throttle control cable (1).
d.
Return the throttle and shift control handle to NEUTRAL position to ensure throttle control cable (1) is
extended to installation length.
e.
Remove rubber grommet (7) from anchor block pocket (8) on front of lower engine cover (9).
f.
Place throttle control cable (1) in the rubber grommet (7).
WARNING
g.
Apply grease to anchor block pocket (8).
h.
Install rubber grommet (7) and throttle cable (1) in anchor block pocket (8).
i.
Position throttle control cable (1) on cable retainer (5) and loosely install with screw (6).
j.
Adjust RHIB engine throttle control rigging. (WP 0272 00)
4.
Install all in line wire bundle clamps and tiedown straps.
5.
Install RHIB engine cover. (WP 0297 00)
6.
Install RHIB battery negative lead terminal. (WP 0336 00)
7.
Perform operational check of RHIB. (TM 55-1945-205-10-2)
END OF WORK PACKAGE