TM 55-1945-205-24-2
0268 00 3/4 blank
0268 00
a.
Verify fast idle lever is down in RUN position.
b.
Move throttle and shift control handle to the REVERSE position to fully extend shift control cable (1).
WARNING
c.
Apply grease to extended cable portion of shift control cable (1).
d.
Move the throttle and shift control handle to FORWARD position to ensure shift control cable (1) is extended
to installation length.
e.
Remove rubber grommet (7) from anchor block pocket (8) on front of lower engine cover (9).
f.
Place shift control cable (1) in the rubber grommet (7).
WARNING
g.
Apply grease to anchor block pocket (8).
h.
Install rubber grommet (7) and shift cable (1) in anchor block pocket (8).
i.
Adjust RHIB engine control rigging. (WP 0272 00)
4.
Install all in line wire bundle clamps and tiedown straps.
5.
Install RHIB engine cover. (WP 0297 00)
6.
Install RHIB battery negative lead terminal. (WP 0336 00)
7.
Perform operational check of RHIB. (TM 55-1945-205-10-2)
END OF WORK PACKAGE
