TM 55-1945-205-24-20269 00 30269 0012. Remove shift control cable (16) from cable trunnion (17).13. Remove drop pin (18) securing shift control cable (16) to shift lever (19).14. Remove control assembly housing (14).15. Remove throttle control cable (20) from cable trunnion (21).16. Carefully slide throttle lever (22) backwards from beneath plastic separator plate (23).17. Remove drop pin (24) securing throttle control cable (20) to throttle lever (22).18. Remove control assembly cover (15).INSTALL RHIB THROTTLE AND SHIFT CONTROL ASSEMBLY1.Place new control assembly housing (14) on a flat surface.2.Ensure the fast idle lever (25) is flush against the control assembly housing (14).CAUTIONDo not remove the plastic separator plate. Failure to comply could cause the control cable drop pins to fall out and jam the control assembly.3.Slide the throttle lever (22) out from under the plastic separator plate (23).WARNING4.Apply outboard motor grease to throttle control cable (20).5.Place the throttle control cable (20) eye between halves of throttle lever (22).WARNING6.Apply outboard motor grease to drop pin (24).7.Install drop pin (24) to secure throttle control cable (20) to throttle lever (22).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
