RIGID HULL INFLATABLE BOAT ENGINE IGNITION COIL

PERFORM RHIB ENGINE SURFACE LEAKAGE TEST (cont)

TM-55-1945-205-24-2 Modular Causeway System (MCS) Roll-On/Roll-Off Discharge Facility Model (RRDF) RRDF-1 NSN 1945-01-473-2282 Manual
Page Navigation
838

TM 55-1945-205-24-2 0310 00 1 0310 00 DIRECT SUPPORT MAINTENANCE ROLL-ON/ROLL-OFF DISCHARGE FACILITY RIGID HULL INFLATABLE BOAT ENGINE IGNITION COIL REPLACEMENT INITIAL SETUP: Tools Tool Kit, General Mechanic’s (Item 81, WP 0359 00) Materials/Parts Assembly, Coil (80256) PN 582508 Personnel Required Engineer 88L References TM 55-1945-205-10-2 Equipment Condition RHIB Dry-Docked. RHIB Engine Cover Removed. (WP 0297 00) RHIB Battery Negative Lead Terminal Removed. (WP 0336 00) REMOVE RHIB ENGINE IGNITION COIL NOTE The following procedure is typical for the removal and installation of RHIB engine ignition coils. Tag and disconnect spark plug wire (1) from ignition coil assembly (2). 1. Remove two mounting screws (3), ground washers (4) and mounting washers (5) securing the ignition coil assembly (2) to the rear and starboard side of the engine. 2. Remove coil assembly (2) and discard. 2 5 4 3 1

Privacy Statement
Press Release
Contact