TM 5-5420-202-20-2
REAR POWERPLANT GUIDE (LEFT OR RIGHT) REPLACEMENT (Sheet 1 of 2)
TOOLS: 9/16 in. combination box and open end wrench
Ball peen hammer
Long round nose pliers
Slip joint pliers
Chisel
B r a s s drift
SUPPLIES:
C o n n e c t i n g ring
Sleeve bearing
Wood block, 4 x 6 (approximately)
REFERENCE:
TM 9-237
P R E L I M I N A R Y PROCEDURE:
Remove powerplant (page 5-2)
REMOVAL:
1.
Using wrench, remove screw (A), lockwasher (B), and flat washer (C) securing rear power-
plant guide assembly (D) to support (E).
2.
Using hammer, tap guide assembly (D) from mounting place. Remove guide assembly from
vehicle.
3.
Using brass drift, drive bearing (F)
f r o m support.
4.
Using long nose pliers, remove cotter
pin (G) and latch (H).
5.
Using chisel, cut ring (J).
6.
Using slip joint pliers, separate ring
(J) and remove ring (J), spring (K), and
pin (L).
Go on to Sheet 2