TM 5-5420-202-20-2
ENGINE MOUNTS (LEFT AND RIGHT) REPLACEMENT (Sheet 3 of 3)
INSTALLATION:
Position bolt (A) through bracket (B) and install
1.
nut (C). Using 1-1/8 inch open end wrench
to hold nut (C) and 1-1/8 inch socket with
3/4 inch drive ratchet, tighten bolt (A).
2.
Install bolt (D) through washer (E), bracket
(B), mount (F), mounting (G), mount (H), and
into bushing (J). Use 1-1/8 inch socket and
3/4 inch drive ratchet and tighten bolt (D),
while holding bushing (J) with 3/4 inch T-slide
and 36 inch bar extension.
Using 1-1/8 wrench to hold bolt (A) and
3.
torque wrench with 1-1/8 inch socket,
tighten nut (C) 135 to 140 ft-lb
(183 to 190 NZm).
4.
Using 3/4 inch T-slide and 36 inch bar ex-
tension to hold bushing (J) and torque
wrench with 1-1/8 inch socket, tighten bolt
(D) 135 to 140 ft-lb (183 to 190 NZm).
Using 1/2 inch socket and 1/2 inch drive
5.
ratchet, install two screws (K) through
washers (L) and bracket (M) into mounting
(G).
6.
Install powerplant (page 5-14).
End of Task
6-7