TM 5-5420-202-20-2
ENGINE MOUNTS (LEFT AND RIGHT) REPLACEMENT (Sheet 2 of 3)
2.
Using 1-1/8 inch open end wrench to hold nut
(D) and 1-1/8 inch socket on bolt (E), remove
nut (D) and bolt (E) from bracket (F).
While holding bushing (G) with 3/4 inch drive
3.
T-slide and 36 inch extension bar, use 1-1/8
inch socket to remove bolt (H) and washer
(J) from bracket (F).
4.
Remove bushing (G), mount (K), mounting
(L), and mount (M) from engine assembly.
C L E A N I N G AND INSPECTION:
Dry cleaning solvent P-D-680 is toxic and
To prevent personal injury, wear
flammable.
protective goggles and gloves and use only in a
well-ventilated area. Avoid contact with skin,
eyes, and clothes and don't breathe vapors. Do
not use near open flame or excessive heat. The
flash point for Type #1 Dry Cleaning Solvent is
100F (38C) and for Type #2 is 138F (50C).
I f you become dizzy while using cleaning
s o v e n t , get fresh air immediately and get
medical aid. If contact with eyes is made, wash
y o u r eyes with water and get medical aid
immediately.
1.
Clean all parts with dry cleaning solvent and
wipe dry with clean rag.
2.
Inspect bushing, mounts, and mountings for
nicks and burrs. Replace damaged parts.
Go on to Sheet 3
6-6