TM 5-5420-202-20-2
TRANSMISSION MOUNTS (LEFT AND RIGHT) REPLACEMENT (Sheet 4 of 4)
3.
Using pliers, install safety wire (D)
between bushing (C) and bracket (A).
4.
Remove from vise and position bracket
(A) onto transmission and, using 3/4
i n c h socket, install three screws (E)
and washers (F) through mount on trans-
mission into bracket (A). Leave screws
loose.
Position spacer (G) into bracket (A) and install
5.
bolt (H), through spacer (G), mount
(A), and washer (J).
6.
With second technician using 1-1/2 inch
open end wrench to hold bolt (H), use 1-1/2
inch socket and torque wrench to tighten
nut (K) to 380 to 415 lb-ft (515-562 NZm).
7.
Position roller (L) onto screw (M) and install
screw (M) through bracket (A).
8.
Using 1/2 inch square drive bit screwdriver
and 1/2 inch drive ratchet to hold screw
(M), use 1-1/4 inch open end wrench to
install nut (N) onto screw (M).
NOTE
It may be necessary to turn universal to
gain access to screw (E).
Using torque wrench and 3/4 inch socket, tighten
9.
screws (E) to 70-75 lb-ft (95-101 NZm).
10.
Install powerplant (page 5-14).
End of Task
6-11
