TM 5-5420-202-20-2
THERMOSTATIC ENGINE OIL COOLER VALVE ASSEMBLY (LEFT AND RIGHT)
REPLACEMENT (Sheet 1 of 4)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
Inspection
Test
Installation
TOOLS: 1-3/4 in. open end wrench
Ruler
Low-pressure compressed air facility (30 psi max)
SPECIAL TOOLS: Ground hop kit (Item 31, Chapter 3, Section I)
SUPPLIES:
Cooking stove (stored in vehicle)
Drip pan
12 in. length of scrap wire
Spacer ring
Pencil (Item 71, Appendix D)
Container
Paper (Item 72, Appendix D)
REFERENCES:
Remove powerplant (page 5-2)
P R E L I M I N A R Y PROCEDURES:
Drain engine oil (page 6-12, steps 4 through 12)
Remove left side engine oil cooler when left
thermostat is to be replaced (page 6-19)
Go on to Sheet 2