TM 5-5420-202-20-2
ENGINE OIL COOLER (LEFT AND RIGHT) REPLACEMENT (Sheet 1 of 6)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
Installation
TOOLS:
1/2 in. socket with 1/2 in. drive
Ratchet with 1/2 in. drive
5 in. extension with 1/2 in. drive
9/16 in. combination box and open end wrench
3/4 in. combination box and open end wrench
1-1/2 in. combination box and open end wrench
Torque wrench with 3/8 in. drive, 0-200 lb-in (0-23 NZm) cap
3/4 in. socket with 3/8 in. drive
SPECIAL TOOLS: Ground hop kit (Item 31, Chapter 3, Section 1)
SUPPLIES
Washer
Drip pan
1/2 inch masking tape
(Item 58, Appendix D)
P l a s t i c barrier material
(Item 42, Appendix D)
Lubricating oil (Item 44, Appendix D)
Gaskets (2 required)
REFERENCES:
P R E L I M I N A R Y PROCEDURES:
Remove powerplant (page 5-2)
Remove engine shroud (page 9-30)
REMOVAL:
1. Using 1/2 inch socket, remove screw and
washer (A).
2. Using 3/4 inch wrench, loosen valve
(B) six complete turns.