TM 5-5420-202-20-2
TUBE ASSEMBLY (FUEL INJECTION PUMP INLET TO BULKHEAD ELBOW)
REPLACEMENT (Sheet 2 of 5)
NOTE
Use suitable container to catch fuel whenever any fuel
line or connection is loosenec or disconnected. Use cloth
to wipe any spillage. Discard cloth and drained furel in
accordance with local procedures.
REMOVAL:
1.
Position drain pan to catch spilled fuel and
using 7/8 inch wrench, remove hose assembly
(A) from bulkhead elbow (B).
2.
Using 1 inch wrench to hold nut (C) of bulkhead
elbow (B) and 7/8 inch wrench, remove tube
assembly (D) from bulkhead elbow (B).
3.
Using 3/ inch wrench to hold bulkhead
elbow (B) and 1 inch open end wrench, remover
nut (C), lockwasher (E) and washer (F) from
bulkhead elbow (B).
4.
Remove bulkhead elbow (B) from engine
bulkhead.
5.
Using 3/8 inch socket and 5/16 inch wrench,
remove two screws and self-locking nuts (G)
from tube clamps (H).
6. Using fingers, remove two tube clamps (H)
from tube assembly (D)
Go on to Sheet 3
7-30