TM 5-5420-202-20-2
TUBE ASSEMBLY (FUEL INJECTION PUMP INLET TO BULKHEAD ELBOW)
REPLACEMENT (Sheet 3 of 5)
7. Using 7/8 inch wrench, remove tube assembly (C)
from fuel injection pump adapter (J).
8.
Using fingers, remove tube assembly (C)
from vehicle.
CLEANING AND INSPECTION:
WARNING
Cleaning agent specified is flam-
mable. Use only in well ventilated
areas. Keep away from flames,
sparks, or heat. DO not smoke
while using. Prevent contact with
eyes, mouth, and/or skin. Wear
rubber gloves when performing
cleaning procedures.
1.
Using clean rags and solvent, clean elbow
and tube assembly mounting hardware
thoroughly. Using wire brush, clean threaded
parts.
Inspect elbow and tube assembly mounting
2.
hardware for bends, breaks,
wear, or thread damage. Replace if required.
Inspect adapter on fuel injection pump for
3.
thread damage.
INSTALLATION:
1. Using 7/8 inch wrench, install tube assembly
(A) on fuel injection pump adapter (B).
Go on to Sheet 4