TM
5-5420-202-20-2
AIR CLEANER DOOR REPAIR (Sheet 1 of 3)
TOOLS:
9/16 in. combination box and open end wrench
Long round nose pliers
Hammer (or mallet)
Slip joint pliers
SUPPLIES:
Gasket
Cotter pins (3 required)
Goggles (Item 70, Appendix D)
Leather gloves (Item 76, Appendix D)
Loctite adhesive (Item 74, Appendix D
Face shield (Item 77, Appendix D)
REMOVAL:
To prevent screws from pulling out
o f box and injuring personnel, a
minimum of 200 pounds must be
p l a c e d atop the door before at-
tempting to remove screws.
NOTE
I f captive screws are used, they
will only be loosened and not
removed.
1.
Using wrench, remove three screws (A).
2.
Using long round nose pliers, pull three
cotter pins (B) out of three straight pins
(c).
3.
Remove flat washers (D).
4.
Using hammer, tap straight pins (C) free
of door hinges (E).
5.
Using slip joint pliers, pull three straight
pins (C) from door hinges.
6.
Lift door assembly (F) and remove it from
air cleaner housing (G).
Go on to Sheet 2
Change 1
