TM 5-5420-202-20-3
STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 17 of 22)
U s i n g 9/16 inch wrench, remove screw
90.
(AV).
Position steering rod end (AT) in clevis
90.
(AU) and using 9/1 6 inch wrench, install
screw (AR).
Using torque wrench tighten screw (AR)
92.
to 16 lb-ft (22 N.m).
Using 9/16 inch wrench to hold steering
93.
r o d end (AW), use 9/16 inch wrench to
loosen jamnut (AX).
Using 9/16 inch wrench, turn steering rod
94.
e n d (AW) counterclockwise until screw
(AV) will drop freely through clevis (AY)
and steering rod end (AW).
U s i n g small gage wire, check if control
95.
rod (AZ) is past witness hole in steering
rod end (AW). If control rod (AZ) is past
witness hole, go to step 96. If control rod
(AZ) is not past witness hole, go on to
step 99.
Using 9/16 inch wrench to hold steering
96.
r o d end (AW), use 9/16 inch wrench to
tighten jamnut (AX).
TA249670
Go on to Sheet 18
15-47