TM 5-5420-202-20-3
STEERING CONTROL LINKAGE ADJUSTMENT (Sheet 19 of 22)
104.
Using 9/16 inch wrench to hold steering
r o d end (BB), use 9/16 inch wrench to
loosen jamnut (BC).
105.
Using 9/16 inch wrench, turn steering rod
end (BB) counterclockwise until screw
(BA) will drop freely through clevis (BD)
and steering rod end (BB).
LEFT OF DRIVER, S STATION
106.
Using 9/16 inch wrench to hold steering rod end (BB), use 9/16 inch wrench to tighten
jamnut (BC).
107.
Using 9/16 inch wrench, install screw (BA) through clevis (BD) and steering rod end
(BB).
108.
Using socket and torque wrench, tighten screw (BA) to 16 lb-ft (22 N.m).
109.
U s i n g 9/16 inch wrench, loosen jamnut
(BE).
110.
Using hands, turn control rod (BF) coun-
terclockwise until control rod (BF) is not
past witness hole in steering rod end (BG).
LEFT SIDE OF HULL
(TO REAR OF FUEL TANK)
TA249672
Go on to sheet 20
15-49