TM 5-5420-202-20-4
PERSONNEL HEATER MOUNT REPLACEMENT (Sheet 1 of 1)
TOOLS:
7/6 in. combination box and open end wrench
9/16 in. combination box and open end wrench (2 required)
SUPPLIES:
Lockwashers (4 required)
PRELIMINARY PROCEDURE:
Remove personnel heater assembly (page 18-2)
REMOVAL:
1.
Using 7/16 inch wrench, remove two screws
(A) and lockwashers (B) securing two clamps
(C) to mount (D).
2.
Remove two clamps (C) and segment (E)
from mount (D).
Using two 9/16 inch wrenches, remove two screws (F), lockwashers (G) and nuts (H) securing
3.
mount (D) to support (J).
4.
Remove mount (D).
INSTALLATION:
1.
Place mount (D) in position on support (J).
2.
Using two 9/16 inch wrenches, install two screws (F), lockwashers (G) and nuts (H) securing
mount (D) to support (J).
3.
Place two clamps (C) and segment (E) in position on mount (D).
4.
Using fingers, install two screws (A) and lockwashers (B) securing clamps (C) to mount
(D).
5.
Using 7/16 inch wrench, tighten screws
(A).
6.
Install personnel heater assembly (page 18-5).
End of Task
TA248615