TM 5-5420-202-20-4
SMOKE GENERATOR TEE-TO-TURBOSUPERCHARGER TUBE ASSEMBLY REPLACEMENT
(Sheet 4 of 5)
INSTALLATION:
If adapter (A) was removed from turbosuper-
1.
charger elbow (B), remove adapter (A)
from replacement tube and, using 1/2
inch wrench, install adapter (A) to turbosuper
charger elbow (B).
If adapter (A) was not removed from
2.
turbosupercharger elbow, remove adapter
(A) from replacement tube and return
adapter to supply.
Position tube (C) to engine and manually connect it to adapter (A).
3.
Position tee (D) and manually connect tube
4.
nuts (E) to tee (D).
5.
Position tee (D) so the open port points
toward solenoid valves (F).
6.
Using 9/16 inch wrench, tighten tube nuts
(E) onto tee (D).
7.
Using 3/4 inch wrench, install 90-degree
elbow (G) to tee (D). Position elbow open
port down.
8.
Using 11/16 inch wrench, connect solenoid
output fuel hose (H) to 90-degree elbow
(G).
Using 1/2 inch wrench to hold adapter (A) in turbosupercharger elbow (B), use 9/16 inch
9.
wrench to tighten tube (C) onto adapter (A).
TA248778
Go on to Sheet 5