TM 5-5420-202-34
FINAL DRIVE REPAIR (Sheet 20 of 30)
Apply light coat of grease to machined
17.
surface of output shaft (A).
Position bearing (M) on output shaft (A).
18.
19.
Using two persons, or lifting device,
position output shaft (A) in arbor press.
Place one output shaft bearing installer
20.
over output shaft (A) with small opening
facing bearing (M). Bearing installer
must engage bearing (M) inner race.
Place second output shaft bearing installer
21.
over output shaft (A) with large opening
facing first bearing installer.
Place metal block on bearing installer.
22.
23.
Aline output shaft (A) under arbor press
ram.
Apply arbor press pressure to seat
24.
bearing (M) on output shaft (A).
Release pressure. Remove metal block and
25.
two bearing installers.
Go on to Sheet 21
7-20 Change 2
