TM 5-5420-226-20-2
MANIFOLD HEATER FUEL RETURN TUBE ASSEMBLY REPLACEMENT (LEFT AND RIGHT
BANK) (Sheet 1 of 7)
PROCEDURE INDEX
PAGE
PROCEDURE
Removal
Cleaning and Inspection
Installation
TOOLS:
5/16 in. combination box and open end wrench
8 in. adjustable wrench
Flat-tip screwdriver
Hammer, 2 lb ball peen
9/16 in. combination box and open end wrench (2 required)
1/2 in. socket with 1/2 in. drive
Ratchet with 1/2 in. drive
1/2 in. combination box and open end wrench
SUPPLIES:
Clean rags (Item 12, Appendix D)
Sealing compound (Item 27, Appendix D)
Dry cleaning solvent (Item 55, Appendix D)
Container
PERSONNEL: TWO
Remove powerplant (page 5-2)
PRELIMINARY PROCEDURES:
Remove engine shroud (page 9-30)
CAUTION
When removing or installing fuel lines, care must be taken
not to damage fittings and threads or twist or distort fuel
lines or hoses.
NOTE
There are two manifold heater fuel return tube assemblies,
one for the left bank and one for the right bank. Removal
and installation procedures for both tube assemblies are
similar. This procedure covers the right bank tube assembly.
TA107883
Go on to Sheet 2