TM 5-5420-227-24
EJECTION CYLINDER REPLACEMENT (LEFT) (Sheet 1 of 4)
PROCEDURE INDEX
I
P R O CE D U R E
PAGE
I
Removal
Installation
TOOLS:
3/8 in. drift punch
Sledge hammer
Flat-tip screwdriver (3/4 to 1 in. across flats)
10 in. adjustable wrench
3/4 in. open end wrench
1-1/2 in. open end wrench
7/8 in. open end wrench
SUPPLIES:
Pipe tape (Item 19, Appendix D)
Container (to catch fluid)
Tags, identification (for hoses)
Wooden block at least 4 in. thick
Protective covers and caps (assorted sizes)
Lockwashers (2 required)
REFERENCES:
PRELIMINARY PROCEDURE:
Extend ejection cylinder's (TM 5-5420-226-10)
REMOVAL:
Place wooden block under tongue (A)
1.
and lower tongue (A) (TM 5-5420-226-10).
NOTE
It may be nacessary to hit plug (B) with
sledge hammer in order to loosen plug (B).
Using punch in hole of plug (B),
2.
unscrew plug (B) while holding
cylinder rod (C) from turning
with screwdriver.
Remove plug (B) from tongue (A).
3.
Relieve hydraulic pressure
4.
Go on to Sheet 2
3-237