TM 5-5420-227-24
EJECTION CYLINDER REPLACEMENT (LEFT) (Sheet 3 of 4)
INSTALLATION:
1.
Position ejection cylinder (A) in tongue (B).
Manually install two screws (C) and new
2.
lockwashers (D) in bottom of tongue (B)
to secure ejection cylinder (A).
Using 1-1/2 inch wrench, tighten two
3.
screws (C) and lockwashers (D).
Manually start plug (E) on threads
4.
of cylinder rod (F).
Using punch in hole of plug (E),
5.
tighten plug (E) while holding
cylinder rod (F) from turning
with screwdriver.
NOTE
Remove protective coverings and put pipe
tape on all male hydraulic fittings.
Using 3/4 inch wrench, install
6.
nipple (G) in ejection cylinder (A).
Using 3/4 inch wrench to hold nipple (G),
7.
use adjustable wrench to install tee (H)
on nipple (G).
Manually place collar "CA" (J) on elbow (K),
8.
collar "CC" (L) on elbow (M), and collar "CB"
(N) on elbow (P).
Manually install elbow (K) on ejection
9*
cylinder (A) and elbows (M, P) on tee (H).
Using adjustable wrench, tighten elbow
10.
(K) on ejection cylinder (A) and elbows
(M, P) on tee (H).
Go on to Sheet 4
3-239